Heat Exchangers - In the Groove

  • Follow steps A through C of the General Installation Procedure (listed above) to prepare and begin laying the gasket tape within the groove.
  • To complete the gasket described in step D below, lay the last 30 cm (1 ft) of the gasket tape in the groove, and mark the location of the starting skive cut using a ball point pen.
  • Perform the closing skive cut on a flat surface.
  • Complete the gasket by removing the rest of the adhesive backing, laying the gasket in the groove, and overlapping the skived cuts.
GORE Gasket Tape Series 500
Sealing in the groove on a heat exchanger

Residents of some states have the right to opt-out of the “sharing” or “selling” of their personal information. Gore does not "sell" the personal information of website users. Gore may "share" the personal information of website users, as standard advertising practice meant to offer you a more personalized service.

If you want to opt-out from Gore “sharing” your personal information, click on Opt-Out of Sharing to turn off the targeting cookies that we share with our advertising partners in order to provide you with personalized information. Disabling sharing will stop the use of cookies to targeted advertising but you may still see generic Gore ads.

Please note that your exercising of the rights outlined will have no adverse effect on the price and quality of our goods or services.

Opt-Out of Sharing

You Have Successfully Opted Out of the Sharing of Your Personal Information

Please note that if you clear your cookies and then use another device or browser, etc. your opt-out status is not transferred to the new device or browser.

Top